Cause If the RIP is stuck on AA or FF and on the printer screen the "Controller Button" is greyed out and in the bottom left hand corner it says "Controller Unconnected" Resolution You will need a USB drive capacity must be 8GB… more »
The Tray Alignment feature shifts and rotates content on the page to correct misalignment problems caused by the imperfections of the paper tray. The correction produces even margins which are ideal for registration on duplex (2-sided) printing. In the… more »
Gamma Automatic Adjustment Power the machine OFF from the main switch leaving the sub switch ON. Turn main power switch ON while pressing the Utility/Counter key. Keep holding it till the comes up in Service mode. -02 process adjustment -06 recall… more »
To combat paper curl make the following adjustments. If printing one side only try delivering face down rather than face up. Change the output curl adjust, Adjustments on the main screen, Machine Adjust, Finisher Adjust, Output Curl Adjust and select… more »
All lightweight paper should be long grain stock. All heavy weight stock should be short grain stock. 450x640 indicates Long Grain - shorter number first is long grain 640x450 indicates Short Grain more »
Cause: Machine indicates that the waste toner bottle is full even after emptied Resolution: As per the image below the part that sticks out that is being pointing to with the pen, that needs to be clean as that is where the photosensor looks through and… more »
Cause Can not connect the Command Workstation to the RIP Resolution Power off the printer by opening the front door and turn off the main switch. Power off Fiery RIP by holding the green light button on the RIP. Leave both off for 5 minutes, power the… more »
Toner Density Revert Power the machine OFF from the main switch leaving the sub switch ON. Turn main power switch ON while pressing the Utility/Counter key. Keep holding it till the comes up in Service mode. Select process adj Select drum peculiarity… more »
Power the machine OFF from the main switch leaving the sub switch ON. Turn main power switch ON while pressing the Utility/Counter key. Keep holding it till the comes up in Service mode. 04 - Counter / Data 03 - Parts Counter 01 - Special Parts 03 -… more »